$39 Diagnostic, Credited to Your Repair

Furnace Repair in Heber City, UT

Cold Heber Valley nights are hard on a furnace. We find what's actually wrong, give you the price in writing first, and get the heat back on. $39 to diagnose it.

  • Licensed & Insured
    Lic #14278324-5501
  • 5-Star Rated
    on Google
  • $39 Diagnostic
    Goes Toward the Repair
  • 24/7
    Emergency Service

Heber Valley Winters Are No Joke

Heber sits at about 5,600 feet in a valley where cold air settles in overnight. It gets colder here than most of the Wasatch Front, and furnaces run long hours from October into spring.

Heber has also grown fast. A lot of the homes in Red Ledges, Timber Lakes, and the newer subdivisions have high-efficiency furnaces that are 10 to 20 years old now, which is right when igniters, inducer motors, and control boards start to go. The older homes near Main Street have their own mix of older furnaces and venting.

We're based in Sandy, under an hour from Heber, up Parleys and down past the Jordanelle. We come over for furnace calls all over the Heber Valley.

What We Fix on Mountain Furnaces

These are the furnace calls we run up here most. Snow, cold, and elevation cause problems you don't see as much in the valley.

Vent pipes buried in snow

High-efficiency furnaces breathe through two PVC pipes on the side of the house. When snow drifts or slides off the roof and covers them, the furnace shuts itself down to stay safe. Up here that happens every winter.

Frozen condensate lines

These furnaces make water. If the drain line runs through a cold garage, crawlspace, or outside wall, it can freeze on a cold night and the furnace locks out until the water can get out.

Furnaces that never get a break

At about 5,600 feet, a furnace runs a lot more hours than one in the valley. Igniters, inducer motors, and blower motors wear out sooner, and a dirty filter does more damage.

Elevation setup

Gas furnaces up here have to be set up for the altitude, per the manufacturer's high altitude instructions. When that step got skipped, we see rough flames, soot, and pressure switch lockouts.

Second homes nobody was watching

A furnace that quits while the house sits empty can mean frozen pipes by the time anyone finds out. We work with owners and property managers to get in, find it, and get the heat back on.

Flame sensors and igniters

Still the most common no-heat calls, anywhere. Quick fixes, and we keep the common parts on the van so we're not driving back down the canyon for one.

Before You Call, Check These

A few of these solve the problem without a service call, and that matters when we're driving up the canyon.

  • Thermostat is set to Heat and a few degrees above the room
  • The two PVC vent pipes outside aren't buried in snow or ice. Clear them by hand, gently.
  • The filter isn't packed with dust
  • Furnace switch and breaker are both on
  • No water around the furnace or a frozen drain line
  • Smell gas? Get everyone out, don't touch any switches, and call Enbridge Gas or 911 from outside
Furnace diagnostic
$39

That's our weekday fee, Monday through Friday, 9am to 5pm, to come out and track down the problem. If we do the repair, the $39 is credited toward it.

Nights, weekends, and holidays: $99.

Schedule a Repair

What Furnace Repair Costs in Heber City

These are the repairs we do most in Heber City and what they usually run. You get the exact number in writing before any work.

RepairTypical price
Flame sensor clean or replaceLights, runs for a minute, then shuts down. This is usually why.$105 to $445
Blower wheel cleaning or replacementYears of skipped filters pack the wheel with dust.$275 to $475
Inducer motor replacementA common big repair on furnaces put in during the 90s.$950 to $1,250
Blower motor replacementWhen the main fan motor finally wears out.$450 to $1,900

Duct repairs and sealing old swamp cooler vents are quoted on site. See our full furnace repair price list for other parts.

Real Furnace Work

Photos from our own furnace calls, not stock pictures.

Furnace secondary heat exchanger before and after cleaning
A secondary heat exchanger before and after cleaning. Skipped filters lead to buildup like this.
Multimeter testing a furnace part
Testing a part with a meter before we replace it. You only pay for what's actually bad.

What Homeowners Say

"Michael is knowledgeable, dependable, thorough, and really cares about helping his customers. He goes above and beyond, taking the time to explain things clearly and making sure everything is handled properly."
Sheila B.HVAC service
"Great team and very responsive, was able to get help with our AC quickly and they were informative without being pushy or overbearing!"
Taylor C.HVAC service
"They did a thorough inspection and cleaned both the indoor coil and outdoor condenser. The technician explained what they were doing, was professional, and left everything clean when they were finished."
Tech M.HVAC tune-up

Heber City Furnace Repair FAQs

How much does furnace repair cost in Heber City?

A weekday diagnostic is $39, and it goes toward the repair if you go ahead. Common parts like a flame sensor or igniter usually run $105 to $450. Bigger parts like an inducer motor or control board run $350 to $1,900. You see the price in writing before we start.

Why does my furnace keep shutting off on the coldest nights?

On a high-efficiency furnace, a frozen condensate line or snow over the vent pipes are the usual suspects. A weak igniter or dirty flame sensor also tends to give out on the first really cold night. We'll find which one it is.

Are there rebates if I end up replacing my furnace?

Enbridge Gas runs the ThermWise rebates for gas furnaces in Heber. Heber's electric comes from Heber Light & Power, not Rocky Mountain Power, so the Rocky Mountain Power heat pump rebates you see advertised don't apply here. Heber Light & Power runs its own rebate program, so it's worth checking with them too. We'll help you sort out what you qualify for.

My furnace is about 15 years old. Should I fix it?

Usually, if it's one part and the heat exchanger checks out. If it needs a big part or keeps breaking, we'll give you the repair price and the replacement price side by side so you can decide.

Do you come to Heber on nights and weekends?

Yes. Nights, weekends, and holidays are a $99 dispatch fee. Weekdays 9 to 5 it's $39, and that goes toward the repair.

Where We Work Around Heber City

All over Heber and the Heber Valley, from the older homes around Main Street to Red Ledges, Timber Lakes, Center Creek, Daniel, Charleston, and the homes up around the Jordanelle.

Downtown HeberRed LedgesTimber LakesCenter CreekDanielCharlestonJordanelleHideout

Furnace Down in Heber? We Can Help

Book online or give us a call. You'll know what's wrong and what it costs before we fix anything.

Scroll to Top