Boiler Repair in Kamas, UT
Cabin on glycol, radiant floors, or a boiler that quit while nobody was there? We fix hot water heat in the Kamas Valley and give you the price in writing first.
- Licensed & Insured
Lic #14278324-5501 - 5-Star Rated
on Google - $39 Diagnostic
Goes Toward the Repair - 24/7
Emergency Service
Boilers for Kamas Homes and Cabins
A lot of homes and cabins in the Kamas Valley heat with a boiler. Radiant floors, baseboard, and glycol loops are common out here, because a system full of plain water can freeze and split if the heat goes out while the place sits empty.
At about 6,500 feet, a boiler has to be set up for the altitude, and it has to keep running through some of the coldest nights in the area. When it doesn't, you want someone who works on boilers, not just furnaces.
We're based in Sandy, about 50 minutes from Kamas, through Park City and out SR-248. If you're not up there, we can work with a gate code or key spot and send you photos of what we find.
Signs Your Boiler Needs Service
Cabins and homes in the Kamas Valley need a boiler that keeps running when nobody's watching. Here's what we see.
Glycol systems in cabins
Glycol keeps the heating loop from freezing if the heat goes out. It does wear out and leak down over time, and it needs to be tested.
Power outages and lockouts
The Kamas area has had its share of outages. Some boilers lock out after the power blinks, and without the pumps running a water-only system can freeze.
Closing up for winter
If you shut a cabin down, the heating system has to be winterized right. That can mean adding glycol, draining lines, or leaving it on low with a temperature alert.
Cabins that sit empty
A boiler that quits while the cabin is empty can mean split pipes by the time you get back. We can get in with a gate code or key spot.
Baseboard that never quite warms up
Air in the lines, a weak pump, or sludge in older baseboard. We bleed it, flush it, and get the heat moving again.
Relief valves dripping
Usually a waterlogged expansion tank or a fill valve pushing too much pressure. Sometimes the valve itself is just worn out.
Quick Checks Before You Call
A couple of these fix more no heat calls than you'd think.
- The thermostat for that zone is set to Heat and above the room temperature
- The boiler's power switch is on. It's often a light switch on the wall or on the boiler itself.
- Look at the pressure gauge. Under 10 psi cold is usually too low.
- Write down any error code on the display
- Radiator valves are open, and furniture isn't blocking baseboard heaters
That's what it costs for us to come out and find the problem, Monday through Friday, 9am to 5pm. Go ahead with the repair and the $39 comes off your bill.
Nights, weekends, and holidays: $99.
Schedule a RepairBoiler Repair Prices
Here's what the common boiler repairs typically run. Every system is a little different, so you get the exact price in writing before any work starts.
| Repair | Typical price |
|---|---|
| Bleed air out of the systemClears the gurgling and the cold spots at the top of radiators or baseboard. Glycol systems may need a top off after. | $250 to $475 |
| Pressure relief valve replacementWhen the valve drips or won't seat. | $345 to $625 |
| Expansion tank replacementA waterlogged tank makes the pressure swing every time the boiler fires. | $365 to $800 |
| Igniter or flame sensorThe usual fix when the boiler tries to fire and locks out. | $295 to $625 |
| Zone valve replacementWhen one area of the house stays cold and the rest heats fine. | $550 to $1,125 |
| Circulator pump replacementThe pump that moves hot water through the house. A failed pump means hot boiler, cold house. | $725 to $1,800 |
| Glycol refill, if neededIf your system runs glycol, opening the lines to bleed air or change a part loses some. Pumping it back in and purging the air takes time. Price covers the labor and the glycol. | $450 to $890 |
| Heat exchanger replacementWhen the heat exchanger cracks or leaks. On some boilers it makes more sense to replace the whole unit, and we'll show you both prices. | $2,000 to $5,500 |
| Boiler replacementA new high efficiency or combi boiler, installed to code. | $8,000 to $16,000 |
These are reference prices, not a bill. We show you what we found and why it needs fixing, then you decide. No pressure either way.
Repair or Replace?
A good boiler can run 25 to 30 years, so most of the time a repair is the right call. Replacing starts to make sense when:
- The heat exchanger or the boiler itself is leaking
- Parts for it aren't made anymore
- You're paying for a repair every winter, or the gas bill keeps climbing
If that's where yours is, we'll give you both prices side by side. A new high efficiency boiler can keep your radiators or radiant floor, and a combi unit can handle your hot water too.
Boiler Work We've Done
Real photos from our jobs. No stock pictures.


What Homeowners Say
"Michael is knowledgeable, dependable, thorough, and really cares about helping his customers. He goes above and beyond, taking the time to explain things clearly and making sure everything is handled properly."Sheila B.HVAC service
"Great team and very responsive, was able to get help with our AC quickly and they were informative without being pushy or overbearing!"Taylor C.HVAC service
"They did a thorough inspection and cleaned both the indoor coil and outdoor condenser. The technician explained what they were doing, was professional, and left everything clean when they were finished."Tech M.HVAC tune-up
Kamas Boiler Repair FAQs
How much does boiler repair cost in Kamas?
It's $39 on a weekday for us to come out and diagnose it, and that goes toward the repair if you go ahead. Common fixes like bleeding air, a relief valve, or an expansion tank run $250 to $800. Bigger parts like a circulator pump or zone valve run $550 to $1,800. If your system runs glycol and we have to open the lines, refilling it runs $450 to $890. You get the price in writing first.
The power went out and now my boiler won't fire. What do I do?
Many boilers lock out after a power interruption. Check that the power switch is on and look for an error code. Some can be reset at the control. If it still won't fire, or you're not there, call us so the lines don't freeze.
Can you winterize my cabin's heating and plumbing?
Yes. We check the glycol, the boiler, and the plumbing, and either drain what needs draining or set it up to run safely on low. We'll walk you through what to do when you come back.
How do I know if my glycol is still good?
It has to be tested. We check the freeze protection and the acidity. Old glycol turns acidic and eats at pumps and fittings, so we recommend testing it every year.
Can you fix it if I'm not up at the cabin?
Yes. Give us a gate code, lockbox, or key spot. We send you photos and the price before any work is done.
Do you come out on nights and weekends?
Yes. Nights, weekends, and holidays are a $99 dispatch fee. Weekdays 9 to 5 it's $39, and that goes toward the repair.
Where We Work Around Kamas
Kamas and the whole Kamas Valley, including Samak, Woodland, Francis, Oakley, Marion, and the cabins up the Mirror Lake Highway.
Boiler Trouble in Kamas?
Book online or give us a call. We'll find the problem and give you the price before we fix anything.
