Furnace Repair in South Jordan, UT
High-efficiency furnace throwing a code? We figure out what it's actually telling you, fix the part that's bad, and give you the price in writing before we start.
- Licensed & Insured
Lic #14278324-5501 - 5-Star Rated
on Google - $39 Diagnostic
Goes Toward the Repair - 24/7
Emergency Service
Newer Furnaces, Smarter Problems
Most of South Jordan has gone up in the last 30 years. East of Bangerter, homes from the 80s and 90s are on their first or second furnace. Out west in Daybreak, the first homes are getting close to 20 years old.
That means a lot of high-efficiency furnaces. They're great on the gas bill, but they have more parts that can quit: condensate drains and pumps, variable speed blower motors, pressure switches, and control boards that talk to fancy thermostats.
South Jordan is just across I-15 from our shop in Sandy. We can often get there the same day.
What We Fix on South Jordan Furnaces
High-efficiency furnaces break in different ways than the old ones. These are the repairs we do most here.
Condensate pump quit
In finished basements, the furnace water often goes to a small pump. When the pump fails, water backs up and the furnace shuts off. Sometimes it floods the floor too.
Variable speed blower failing
Lots of newer furnaces have an ECM blower motor. When its control module goes, the blower won't run even though the furnace lights.
Pressure switch faults
A flashing code for the pressure switch can mean a blocked vent, a plugged drain, a cracked hose, or a bad switch. We test each one instead of guessing.
Smart thermostat mismatch
Two stage and variable speed furnaces need to be wired and set up right. A thermostat set up wrong can short cycle the furnace or leave it on low all day.
Thick media filters left too long
A lot of South Jordan homes have 4 or 5 inch filters. They last longer, but not forever. A plugged one chokes airflow and trips the high limit.
Original furnaces east of Bangerter
Older neighborhoods have 80% furnaces from the 80s and 90s. Those need a hard look at the heat exchanger and inducer.
Read the Code First
Most high-efficiency furnaces blink a code through a little window in the door. Snap a picture of it before you call, along with these checks.
- Count the blinks on the board light, or take a short video of it
- Thermostat is on Heat and asking for more than the room temperature
- No water around the furnace or the condensate pump
- The white PVC pipes outside aren't blocked by snow, leaves, or bushes
- Thick media filter isn't gray and packed
- Smell gas? Get everyone out first and call Enbridge Gas or 911 from outside
Our diagnostic fee for weekdays, Monday through Friday, 9am to 5pm. If we do the repair, that $39 comes off the total.
Nights, weekends, and holidays: $99.
Schedule a RepairFurnace Repair Prices in South Jordan
Common repairs on South Jordan furnaces and what they typically run. You'll have your exact price in writing first.
| Repair | Typical price |
|---|---|
| Flame sensor clean or replaceThe most common fix on a furnace that lights and then shuts off. | $105 to $445 |
| Igniter replacementCracked igniters are common at 10 to 20 years. | $300 to $450 |
| Blower motor replacementIncludes variable speed motors. Cost depends a lot on the motor. | $450 to $1,900 |
| Control board replacementBoards on newer furnaces can fail after a surge or from water. | $350 to $1,900 |
Condensate pumps and drain repairs are priced on site, and parts may be under warranty on a newer furnace. See our full furnace repair price list.
Inside Furnaces We Service
Real pictures from our furnace calls. This is what's going on behind the panel.
South Jordan Furnace Repair FAQs
What does furnace repair cost in South Jordan?
A weekday diagnostic is $39 and goes toward the repair. Small parts like a flame sensor or igniter run $105 to $450. Bigger parts like a blower motor or control board run $350 to $1,900, depending on the furnace. You see the price in writing before we start.
My furnace is blinking a code. What does it mean?
Each brand uses its own codes, usually listed on a sticker inside the door. A code tells us where to start looking, not always what's broken. Send us a picture when you book and we'll come ready.
Water is coming out of my furnace. Is that bad?
On a high-efficiency furnace it usually means the condensate drain, trap, or pump is plugged or failed. Turn the furnace off, wipe up the water, and give us a call before it reaches the control board.
Is my Daybreak furnace still under warranty?
If it was registered, many furnaces have a 10 year parts warranty. The first Daybreak homes are past that now, but newer ones may still be covered. We check the serial number before we quote.
How fast can you get to South Jordan?
Our shop is just across I-15 in Sandy, so same day is often possible. Nights and weekends are a $99 dispatch fee.
Where We Work in South Jordan
Across the whole city, from Daybreak and Oquirrh Lake to Glenmoor, the neighborhoods along South Jordan Parkway, and the older streets down by the Jordan River.
Furnace Down in South Jordan?
Book online or give us a call. Send a picture of the code and we'll come ready to fix it.