Furnace Repair in American Fork, UT
We come over the Point of the Mountain to American Fork every week. $39 to find out why your furnace quit, and the price in writing before any work.
- Licensed & Insured
Lic #14278324-5501 - 5-Star Rated
on Google - $39 Diagnostic
Goes Toward the Repair - 24/7
Emergency Service
An Old Town With a Lot of 90s Houses
American Fork was settled in 1850, and some of the homes near Main Street go back a long way. But most of the city went up later. The typical house here was built in the mid 90s.
So most furnace calls in American Fork are builder grade furnaces that are 25 to 30 years old, plus newer high-efficiency units in the neighborhoods that went up since. The older homes downtown have their own mix, often a newer furnace tied into old ductwork or an old chimney.
We're about 25 minutes from our shop in Sandy and in Utah County every week. No trip charge, same price as Sandy.
What Goes Wrong on American Fork Furnaces
These are the repairs that come up most on American Fork furnaces, from the old downtown houses to the newer neighborhoods.
Rollout switch tripping
A rollout switch trips when flame comes out of the burner area. On an old furnace it's often a blocked flue or a dirty heat exchanger. It's a warning, not something to just reset.
Worn out inducer bearings
A 25 year old inducer gets loud, then slow. The furnace waits for the pressure switch and gives up.
Rusted parts from a leaky humidifier or drain
Water dripping into a furnace for years rusts the burners and cabinet. We trace where it's coming from, not just what it broke.
Weak airflow upstairs
Mid 90s two stories often have long duct runs to the bedrooms. Dirty blowers and closed dampers make it worse.
Igniters and flame sensors
Cheap parts that cause most of the no-heat calls. We carry them on the van.
Downtown homes with old ducts
In the older houses near Main Street, the furnace is newer than the ductwork and the venting. We check how it was put in.
Before You Book
Run through these first. If the furnace still won't heat, we're about 25 minutes away.
- Thermostat is set to Heat and above the room temperature
- Filter isn't clogged with dust
- Furnace switch and breaker are on
- The furnace door is shut tight
- Outside vent pipes are clear, if you have a high-efficiency furnace
- Smell gas? Get out of the house, leave the switches alone, and call Enbridge Gas or 911 from outside
That's what it costs for us to come out and diagnose it, Monday through Friday, 9am to 5pm. If you go ahead with the repair, we take the $39 off. No extra charge for the drive.
Nights, weekends, and holidays: $99.
Schedule a RepairFurnace Repair Prices in American Fork
What the common furnace repairs run in American Fork. You get your exact price in writing before we start.
| Repair | Typical price |
|---|---|
| Inducer motor replacementThe most common big part on a mid 90s furnace. | $950 to $1,250 |
| Igniter replacementA cracked igniter means the furnace tries to light and gives up. | $300 to $450 |
| Blower wheel cleaning or replacementA caked wheel is behind a lot of weak airflow calls. | $275 to $475 |
| Control board replacementOld boards wear out. We test it first so you don't buy one you don't need. | $350 to $1,900 |
Rollout and venting problems are quoted once we see the cause. See our full furnace repair price list for everything else.
Real Furnace Jobs
Photos from furnaces we've worked on, not stock pictures.
American Fork Furnace Repair FAQs
What does furnace repair cost in American Fork?
A weekday diagnostic is $39, and it comes off the repair if you go ahead. Igniters and blower wheel work run $275 to $475. An inducer motor runs $950 to $1,250. You see the price in writing before we start.
Is it worth calling a company from Sandy?
We think so. It's about 25 minutes, there's no extra trip charge, and you get the same small crew and written pricing as our Sandy customers. We're in Utah County every week.
My furnace's rollout switch keeps tripping. Can I just reset it?
You can reset it once, but if it trips again, turn the furnace off and call us. It means flame is coming out where it shouldn't, usually from a blocked flue or heat exchanger. That's a safety problem.
My furnace is from the 90s. Should I fix it or replace it?
If it's one part and the heat exchanger checks out, a repair usually makes sense. If it's a big part on a furnace that's 25 years old or more, we'll give you both prices and you decide.
Do you come to American Fork at night or on weekends?
Yes. After hours, weekends, and holidays are a $99 dispatch fee. Weekdays 9 to 5 it's $39, and that goes toward the repair.
Where We Work in American Fork
All of American Fork, from the older streets near Main Street to the neighborhoods by the Mount Timpanogos Temple, American Fork Hospital, The Meadows, and up toward the canyon.
American Fork Furnace Acting Up?
Book online or give us a call. We'll find what's wrong and give you the price before we start.